Enjoy 10% OFF on your first order with code FIRST10

OUR PAPERS

classic

NON WOVEN TRADITIONAL WALLPAPER

This non-woven wallpaper is a ‘paste the wall product’. You just need to paste the wall and not the back of the wallcovering.

Printed in U.K, this non woven wallpaper is FSC certified which means it comes from a managed forest source and all inks used are water based, which makes it environmentally friendly.

Hanging instruction :
Walls should be clean, dry and even.
Remove any old wallcovering and loose paint and scrape off powdery, flaky surfaces.
You need a premium quality tub adhesive, or an equivalent good quality pH neutral, solvent-free, fungicide protected, light grade adhesive should be used.
DO NOT USE SELF-MIX ADHESIVES. ALL PURPOSE AND HEAVY DUTY PASTES ARE NOT SUITABLE.
Paste should be evenly applied to the wall to hang 1 length at a me, to an area slightly wider than the width of the roll.
Butt joins and use a decorator’s brush to smooth down the wallcovering, working from the centre to the edges to express air bubbles. NB. If this is a flocked wallcovering, use only a clean, soft roller, NOT a decorator’s brush.
Avoid squeezing paste out of joins and ensure paste does not get onto the brush or roller. No paste should be allowed to come into contact with the surface of the paper and hands should be kept clean and dry whilst handling the wallcovering.

adhesif

PEEL & STICK WALLPAPER - REPOSITIONABLE

This repositionable wallpaper is easily removed, repositioned and reused. It comes off without leaving residue and is washable. It is perfect for DIY room, furniture or any architecture element compare to a traditional wallpaper.

This is a very ecological wallpaper which is coated with a solvent-free adhesive, permanently elastic, resistant to ageing and cadmium-free.

Printed in France with water based inks, this paper is respectful of the environment with excellent colour rendering.

prepasted

PRE-PASTED MAT WALLPAPER

The pre-pasted mat wallpaper is a non-woven wallpaper, which does not require gluing on the back, you just need to glue the wall mount with a special non-woven paper glue and glue brush. The back of the wallpaper needs to be reactivated by a simple spray of water. It is easy to reposition during installation and it does not shrink during drying, suitable for all interior walls with the exception of structured surfaces in particular glass textured canvases.

Printed in France with water based inks, and consisting of cellulose fibre and polyester this paper is respectful of the environment with excellent colour rendering.

Hanging instruction :
Be careful not to spray too much water in order to avoid dripping glue, these runs must be sponged delicately and quickly with a slightly damp sponge.
For the preparation of the glue well refer to the instructions of the supplier of it. Our non-woven wallpapers can be placed edge-to-edge without any shrinkage during drying, or with an overlap (recommended at 0.5 cm).
For a good bond, before laying make sure that the support is clean and not too structured.
For widths greater than 90cm, it is advisable to pose with two. When handling the strips, avoid folding the paper so that it does not have any marks after installation.
After wedging the stripe on the wall, well rub from the centre to the outside to chase the bubbles and ensure the proper grip of the glue.
Cut the excess paper with the aid of a screed.